Millenia S V6-2.3L DOHC (Miller cycle) (2000)
Tilt Wheel Motor: All Technical Service Bulletins
Steering - Tilt Steering Wheel Inoperative
Bulletin No: 06-001/01R1
Last Issued: 11/1/2001
Subject:
TILT STEERING WHEEL INOPERATIVE
BULLETIN NOTE
This bulletin supersedes 06-001/01R, issued on 10/4/2001. The APPLICABLE MODEL(S)/VINs section of this bulletin has been revised.
APPLICABLE MODEL(S)/VINs
All 1997-2002 Millenia.
DESCRIPTION
Some vehicles may exhibit inoperative tilt steering when the key is inserted and/or removed from the ignition.
Customers having this concern should have their vehicle repaired using the following procedure.
REPAIR PROCEDURE
1.
Verify customer concern.
Note:
Be sure the auto button on tilt switch is pushed in.
2.
Disconnect any aftermarket installed accessories that may interfere with tilt operation.
3.
Verify tilt operation.
-
If tilt operation is still inoperative, proceed to STEP 4.
-
If tilt operation is now functional, return vehicle to customer.
4.
Perform TILT RELAY INSPECTION according to section 06-15 of the Workshop Manual.
-
If tilt relay fails continuity inspection, replace relay and proceed to STEP 12.
-
If tilt relay passes inspection, proceed to STEP 5.
5.
Remove tilt motor using the following steps:
A.
Record radio presets.
B.
Disconnect negative battery cable.
C.
Working from under the lower dash panel, use a small angled ratchet with a phillips tip (Craftsman # 41717 or equivalent) to remove four
(4) screws from tilt motor.
Note:
If screws can not be loosened, use needle-nose type vise-grips to break screws loose.