Millenia S V6-2.3L DOHC (Miller cycle) (2000)
/Page-1157002.png)
D.
Disconnect tilt motor connector.
E.
Remove tilt motor.
6.
Perform tilt motor inspection using the following steps.
A.
Inspect for continuity between the tilt motor terminals as shown in the illustration shown.
-
If there is no continuity, proceed to STEP 7.
-
If there is continuity, refer to DIAGNOSIS CHART in section 06-15 of the Workshop Manual for troubleshooting information.
7.
Install new tilt motor using supplied screws.