MPV ES V6-2.5L DOHC (2001)
2. As shown in the figure, insert a pry bar between the drive shaft and the joint shaft and tap on the bar to uncouple them.
Joint Shaft Installation Note
1. Secure the shaft portion of the drive shaft in a vise.
2. Install the joint shaft using a plastic hammer as shown
Clip Installation Note
1. Install a new clip onto the joint shaft with the opening facing upward. Ensure that the diameter of the clip does not exceed the specification on
installation.
2. After installation, measure the outer diameter. If it exceeds the specification, repeat steps 1-2 using a new clip.
Outer diameter specification 30.9 mm (1.21 inch)
Drive Shaft (Right Side) and Joint Shaft Installation Note
1. Apply ATF to the oil seal lip.
2. Push the drive shaft and joint shaft into the transaxle.
Caution:
-
The sharp edges of the joint shaft can slice or puncture the oil seal. Be careful when installing the joint shaft to the transaxle.
Drive Shaft (Left Side) Installation Note
1. Insert the drive shaft into the wheel hub.
2. Apply ATF to the oil seal lip.
3. Push the drive shaft into the transaxle.
Caution: