MX-3 L4-1598cc 1.6L DOHC (1995)
Mass Air Flow Sensor: Testing and Inspection
CAUTION:
-
Do not drop subject the sensor to sharp shocks.
-
Do not put or allow anything in the sensor.
View: Removing The Mass Airflow Sensor
VISUAL INSPECTION
-
Disconnect the mass air flow sensor connector.
-
Remove the mass air flow sensor.
-
Check for damage of the sensor.
-
Install the mass air flow sensor.
Connect Special Service Tools As Shown
VOLTAGE INSPECTION
-
Disconnect the engine control module (ECM) connectors.
-
Connect the special service tool (SST) (Engine Signal Monitor and Adapter Harness) to the ECM as shown.
-
Place the SST (Sheet) on the SST (Engine Signal Monitor).
View: Test Specifications
-
Check the voltage of terminals 2O and 2F.
-
If not as specified, replace the mass air flow sensor.
Tightening torque: 7.9 - 10.7 Nm (70 - 95.4 in.lb.)