Connecting rod cap
- Make
- Mazda
- Model
- MX-5 (NA) Factory Workshop Manual
- Year
- 1990–1992
- Section
- B Engine (B) › Connecting rod cap
EngineConnecting rod cap
Disassembly Note
Connecting rod cap
- Before removing the connecting rod caps, measure the connecting rod side clearance. (Refer to page B–65.)
Connecting rod
- Before removing the connecting rods, measure the connecting rod oil clearance. (Refer to page B–65.)
- Remove the Plastigage from the crankpin journals.
Caution
- Do not scratch the crankshaft journal or the cylinder wall.
- Use the handle of a hammer to remove the piston and connecting rod assembly through the top of the cylinder block.
Piston ring
Caution
- Do not apply excessive tension, which may cause the rings to snap out.
- Remove the piston rings with a piston ring expander (commercially available).
Piston pin
Caution
- Mark the connecting rod direction for proper reassembly.
- Remove the piston pin with the SST.
Parts & tools for this job For 1990 Mazda MX-5
- PARTEngine gasket setSearch: Mazda MX-5 1990 engine gasket set
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLFeeler gauge setSearch: feeler gauge set
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.