Oil Jet
- Make
- Mazda
- Model
- MX-5 (NA) Factory Workshop Manual
- Year
- 1990–1992
- Section
- B Engine (B) › Oil Jet
Oil Jet
- Install the oil jets.
Tightening torque:
12—18 N·m (1.2—1.8 m-kg, 104—156 in-lb)
Crankshaft
- Before installing the crankshaft, inspect the main bearing oil clearances as follows.
Oil clearance inspection
(1) Remove all foreign material and oil from the journals and bearings.
Caution
- Install the grooved upper main bearings in the cylinder block.
- Install the thrust bearings with the oil groove facing the crankshaft.
(2) Install the upper main bearings and thrust bearings.
(3) Set the crankshaft in the cylinder block.
Caution
- Do not rotate the crankshaft when measuring the oil clearances.
(4) Position Plastigage atop the journals in the axial direction.
(5) Install the lower main bearings and the main bearing caps according to the cap number and ⇐ mark.
(6) Tighten the main bearing cap bolts in two or three steps in the order shown in the figure.
Tightening torque:
54—59 N·m (5.5—6.0 m-kg, 40—43 ft-lb)
Parts & tools for this job For 1990 Mazda MX-5
- PARTOil filterSearch: Mazda MX-5 1990 oil filter
- TOOLOil filter wrenchSearch: oil filter wrench
- FLUIDEngine oilSearch: Mazda MX-5 engine oil
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.