Oil seal
- Make
- Mazda
- Model
- MX-5 (NA) Factory Workshop Manual
- Year
- 1990–1992
- Section
- Oil seal, Flywheel › Oil seal
EngineOil seal
Oil seal
- Cut the oil seal lip with a razor knife.
- Remove the oil seal with a screwdriver protected with a rag.
Installation note
Oil seal
- Apply a small amount of clean engine oil to the lip of a new oil seal.
- Push the oil seal slightly in by hand.
Caution
- The oil seal must be tapped in until it is flush with the edge of the rear cover.
- Tap the oil seal in evenly with a suitable pipe and a hammer.
Oil seal outer diameter: 100mm (3.94 in)
Flywheel
- Remove the sealant from the flywheel bolt holes in the crankshaft and from the flywheel bolts.
Caution
- If all the previous sealant cannot be removed from a bolt, replace the bolt.
- Do not apply sealant if a new bolt is used.
- Set the flywheel onto the crankshaft.
- Apply sealant to the flywheel bolts and install them.
- Hold the flywheel with the SST.
- Tighten the bolts in two or three steps in the order shown in the figure.
Tightening torque:
96—103 Nm (9.8—10.5 m-kg, 71—76 ft-lb)
Steps After Installation
- Connect the negative battery cable.
- Start the engine and perform engine adjustments as necessary.
Parts & tools for this job For 1990 Mazda MX-5
- PARTOil filterSearch: Mazda MX-5 1990 oil filter
- TOOLOil filter wrenchSearch: oil filter wrench
- FLUIDEngine oilSearch: Mazda MX-5 engine oil
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.