Removal / Installation
- Make
- Mazda
- Model
- MX-5 (NA) Factory Workshop Manual
- Year
- 1990–1992
- Section
- Removal / Installation › Removal / Installation
EngineRemoval / Installation
Removal / Installation
Caution
- Obtain the code number and deactivate the audio anti-theft system before disconnecting the battery. (Refer to page T–113.)
- Position the hose clamp in the original location on the hose, and squeeze the clamp lightly with large pliers to ensure a good fit.
- Disconnect the negative battery cable.
- Drain the engine coolant.
- Remove in the order shown in the figure, referring to Removal Note.
- Install in the reverse order of removal, referring to Installation Note.
- Air intake pipe
- Upper radiator hose
- Water hoses (Connect to thermostat housing)
- P/S and/or A/C drive belt
Removal / Installation.................... page B– 6 - Alternator drive belt
Removal / Installation.................... page B– 6 - Water pump pulley
- Plate
- Crankshaft pulley
- Timing belt guide plate, outer
- Timing belt guide plate, inner
Installation Note.................... page B–15 - Ignition coil and high-tension lead
- Spark plug
Installation Note.................... page B–15 - Cylinder head cover
Installation Note.................... page B–15 - Timing belt cover, upper
- Timing belt cover, middle
- Timing belt cover, lower
- Timing belt
Removal Note.................... page B–13
Installation Note.................... page B–13
Inspection.................... page B–59 - Tensioner, tensioner spring
Installation Note.................... page B–13
Inspection.................... page B–59 - Idler
Inspection.................... page B–59
Parts & tools for this job For 1990 Mazda MX-5
- PARTEngine gasket setSearch: Mazda MX-5 1990 engine gasket set
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLFeeler gauge setSearch: feeler gauge set
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.