Fuel pump
- Make
- Mazda
- Model
- MX-5 (NA) Factory Workshop Manual
- Year
- 1990–1992
- Section
- Fuel pump › Fuel pump
Fuel and emission control systemsFuel pump
FUEL PUMP
Caution
• Obtain the code number and deactivate the audio anti-theft system before disconnecting the battery. (Refer to page T–113.)
Inspection
Fuel pump operation
- Connect the diagnosis connector terminals F/P and GND with a jumper wire.
- Remove the fuel filler cap.
- Turn the ignition switch ON.
- Listen for operational sound of the fuel pump at the filler inlet.
- Install the fuel filler cap.
- If no sound was heard, measure the voltage between the fuel pump connector wire to ground.
Voltage: 12V
- If not correct, check the circuit opening relay and its circuits. (Refer to page F–109.)
- If the voltage is normal, check for continuity between fuel pump connector (B) and a ground.
- If there is continuity, replace the fuel pump.
- If no continuity, repair the ground circuit.
Hold pressure
Perform this inspection if the fuel pressure hold inspection is not as specified. (Refer to page F–102.)
Warning
• Before performing the following operation, release the fuel pressure from the fuel system to reduce the possibility of injury or fire. (Refer to page F–101.)
- Disconnect the negative battery terminal.
- Connect a fuel pressure gauge to the fuel main pipe and plug the outlet of the fuel pressure gauge as shown. (Install clamps as shown.)
- Connect the negative battery terminal.
Parts & tools for this job For 1990 Mazda MX-5
- PARTFuel filterSearch: Mazda MX-5 1990 fuel filter
- TOOLFuel pressure test kitSearch: fuel pressure test kit
- TOOLFuel line disconnect toolSearch: fuel line disconnect tool
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.