Symptom troubleshooting
- Make
- Mazda
- Model
- MX-5 (NA) Factory Workshop Manual
- Year
- 1990–1992
- Section
- Symptom troubleshooting › Symptom troubleshooting
| CRANKS NORMALLY BUT WILL NOT START (NO COMBUSTION) | |||
|---|---|---|---|
| DESCRIPTION |
|
||
|
[TROUBLESHOOTING HINTS] |
|||
| STEP | INSPECTION | ACTION | |
| 1 | Check if strong blue spark is visible at disconnected high-tension lead while cranking engine | Yes | Go to Step 3 |
| No | Go to Step 2 | ||
| 2 | Check if "00" is displayed on Self-Diagnosis Checker with ignition switch ON page F–78
|
Yes | Check ignition system (Refer to Troubleshooting "Misfire") page G–18 |
| No | Malfunction Code No. displayed Check for cause (Refer to specified check sequence) page F–80 |
||
| "88" flashes Check ECU terminal 1F voltage page F–128 Voltage: Approx. 12V (Ignition switch ON) |
|||
| ⇒ If OK, replace ECU page F–127 ⇒ If not OK, check wiring between ECU and Self-Diagnosis Checker page F–7 |
|||
| 3 | Connect diagnosis connector terminals F/P and GND with jumper wire and check for fuel pump operating sound with ignition switch ON page F–107 |
Yes | Check if engine starts in this condition |
| ⇒ If starts, check circuit opening relay page F–110 ⇒ If does not start, go to Step 5 |
|||
| No | Go to Step 4 | ||
Parts & tools for this job For 1990 Mazda MX-5
- PARTExhaust gasketSearch: Mazda MX-5 1990 exhaust gasket
- TOOLPenetrating oilSearch: penetrating oil
- TOOLOBD2 scannerSearch: OBD2 scanner
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.