System operation
- Make
- Mazda
- Model
- MX-5 (NA) Factory Workshop Manual
- Year
- 1990–1992
- Section
- System operation › System operation
Fuel and emission control systemsSystem operation
SYSTEM OPERATION
Caution
- Obtain the code number and deactivate the anti-theft system before disconnecting the battery. (Refer to page T–113.)
Fuel Pressure Hold Inspection
Warning
• Before performing the following operation, release the fuel pressure from the fuel system to reduce the possibility of injury or fire. (Refer to page F–101.)
- Disconnect the negative battery terminal.
- Install a fuel pressure gauge between the fuel pipe and the fuel main hose. (Install clamps as shown.)
- Connect the negative battery terminal.
- Connect diagnosis connector terminals F/P and GND with a jumper wire.
- Turn the ignition switch ON for 10 sec. to operate the fuel pump.
- Turn the ignition switch OFF and disconnect the jumper wire.
- Observe the fuel pressure after 5 min.
Fuel pressure:
More than 147 kPa (1.5 kg/cm², 21 psi)
- If not as specified, perform the following inspections.
- Fuel pump hold pressure (Refer to page F–107.)
- Pressure regulator hold pressure (Refer to page F–111.)
- Injector fuel leakage. (Refer to page F–113.)
Parts & tools for this job For 1990 Mazda MX-5
- PARTExhaust gasketSearch: Mazda MX-5 1990 exhaust gasket
- TOOLPenetrating oilSearch: penetrating oil
- TOOLOBD2 scannerSearch: OBD2 scanner
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.