Troubleshooting guide (F)
- Make
- Mazda
- Model
- MX-5 (NA) Factory Workshop Manual
- Year
- 1990–1992
- Section
- Troubleshooting guide (F) › Troubleshooting guide (F)
Fuel and emission control systemsTroubleshooting guide (F)
| STEP | INSPECTION | ACTION | |
|---|---|---|---|
| 6 | Check for injector operating sound at idle with sound scope or screwdriver | Yes | Go to Step 8 |
| No | Go to Step 7 | ||
| 7 | Check if approx. 12V exists at injector connector (W/R) wire | Yes | Check if injector resistance is OK page F–112 Resistance: Approx. 14Ω ⇒ If OK, check wiring between ECU and injector page F–7 ⇒ If not OK, replace injector page F–112 |
| No | Check wiring between ECU and injector page F–7 | ||
| 8 | Disconnect each high-tension lead at idle and check if engine speed decreases equally each time | Yes | Disconnect each injector connector at idle and check if engine speed decreases equally each time ⇒ If OK, go to Step 10 ⇒ If not OK, check injector for fuel leakage page F–113 |
| No | Go to step 9 | ||
| 9 | Check if spark plugs are OK WEAR AND CARBON BUILDUP PLUG GAP 1.0—1.1mm (0.039—0.043 in) BURNS DAMAGE AND DETERIORATION DAMAGE |
Yes | Check for correct engine compression page B–10 ⇒ If OK, replace injector page F–112 ⇒ If not OK, check for cause (Refer to Section B) page B–10 |
| No | Repair, clear, or replace page G–20 | ||
| 10 | Check for correct ignition timing at idle page F–75 Ignition timing: 10° ± 1° BTDC GND TEN CONNECT TERMINALS |
Yes | Check for correct idle speed page F–76 Idle speed: 850 ± 50 rpm ⇒ If OK, go to next step ⇒ If not OK, adjust idle speed page F–76 |
| No | Adjust page F–75 | ||
| 11 | Check for correct fuel line pressure at idle page F–103 Fuel line pressure: 265—314 kPa (2.7—3.2 kg/cm², 38—48 psi) (Vacuum hose to pressure regulator disconnected) INSTALL CLAMPS |
Yes | Go to next step |
| No | Low pressure Check fuel line pressure while pinching fuel return hose ⇒ If fuel line pressure quickly increases, check pressure regulator page F–111 ⇒ If fuel line pressure gradually increases, check for clogging between fuel pump and pressure regulator If not clogged, check fuel pump maximum pressure page F–108 |
||
| 12 | Try known good ECU and check if condition improves page F–127 |
Parts & tools for this job For 1990 Mazda MX-5
- PARTExhaust gasketSearch: Mazda MX-5 1990 exhaust gasket
- TOOLPenetrating oilSearch: penetrating oil
- TOOLOBD2 scannerSearch: OBD2 scanner
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.