Alternator
- Make
- Mazda
- Model
- MX-5 (NA) Factory Workshop Manual
- Year
- 1990–1992
- Section
- Alternator › Alternator
Engine electrical systemAlternator
ALTERNATOR
Caution
- Obtain the code number and deactivate the audio anti-theft system before disconnecting the battery. (Refer to page T–113.)
- Be sure the battery connections are not reversed because this will damage the rectifier.
- Do not use high-voltage testers such as a megger because they will damage the rectifier.
- Remember that battery voltage is always applied to the alternator B terminal.
- Do not ground the L terminal while the engine is running.
- Do not start the engine while the connector is disconnected from the L and S terminals.
SELF-DIAGNOSIS SYSTEM
The alternator has a self-diagnostic function to warn of problems in the charging system.
If any of the following problems arise, the alternator warning lamp illuminates.
- S circuit open.
- No voltage output.
- Field circuit open.
- B circuit open.
- Voltage output too high.
Removal / Installation
- Disconnect the negative battery cable.
- Disconnect the P/S pressure switch connector.
- Disconnect the water thermoswitch connector.
- Disconnect the ISC valve connector.
- Remove the air pipe.
- Disconnect the wire and connector from the alternator.
- Remove the alternator bolts and nut.
- Remove the alternator.
- Install in the reverse order of removal.
Tightening torque
Bolt, Nut (1):
37—52 N·m (3.8—5.3 m·kg, 27—38 ft-lb)
Bolt (2):
19—25 N·m (1.9—2.6 m·kg, 14—19 ft-lb)
Nut (3):
9.8—15 N·m (100—150 cm·kg, 87—130 in-lb)
Parts & tools for this job For 1990 Mazda MX-5
- TOOLBattery testerSearch: car battery tester
- TOOLDigital multimeterSearch: automotive digital multimeter
- TOOLBattery terminal cleanerSearch: battery terminal cleaner
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.