Inspection
- Make
- Mazda
- Model
- MX-5 (NA) Factory Workshop Manual
- Year
- 1990–1992
- Section
- Inspection Armature › Inspection
Inspection
Armature
- Ground of armature coil
Check for no continuity between the commutator and the core with an ohmmeter. Check the entire circum ferance of the commutator. Replace the armature if there is con-tinuity.
- Insulation of armature coil
Check for no continuity between the commutator and the shaft with an ohmmeter. Check the entire circum ferance of the commutator. Replace the armature if there is con-tinuity.
- Runout of commutator
- Place the armature on V blocks, and measure the runout with a dial gauge.
- Repair with a lathe if the runout is small or replace the armature if necessary.
Runout: 0.03mm (0.001 in)
- Outer diameter of commutator
Replace the armature if the outer diameter of the commu-tator is at the grind limit or less.
- Roughness of commutator surface
If the commutator surface is dirty, wipe it with a cloth; if it is rough, repair it with a lathe or fine sandpaper.
Grind limit: 30.8mm (1.21 in)
- Segment groove depth
If the depth of the molding between segments is at the depth limit or less, undercut the grooves to the standard depth.
Standard depth: 0.5—0.8mm (0.020—0.031 in)
Depth limit: 0.2mm (0.008 in)
Parts & tools for this job For 1990 Mazda MX-5
- PARTEngine gasket setSearch: Mazda MX-5 1990 engine gasket set
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLFeeler gauge setSearch: feeler gauge set
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.