Inspection
- Make
- Mazda
- Model
- MX-5 (NA) Factory Workshop Manual
- Year
- 1990–1992
- Section
- Inspection (G) › Inspection
Inspection
Rotor
- Winding damage
(1) Check the resistance between the slip rings with an ohmmeter.
Specification: 3.5—4.5Ω/20°C (68°F)
(2) If it is not within specification, replace the rotor.
- Ground of field coil
(1) Check for continuity between each slip ring and the core with an ohmmeter.
(2) Replace the rotor if there is continuity.
- Slip ring surface
If the slip ring surface is rough, use fine sandpaper to repair it.
Stator
- Wiring damage
(1) Check for continuity between the stator coil leads with an ohmmeter.
(2) Replace the stator if there is no continuity.
- Ground of stator coil
(1) Check for no continuity between the stator coil leads and the core with an ohmmeter.
(2) Replace the stator if there is continuity.
Brush
If the brushes are worn almost to or beyond the limit, replace them.
Standard: 21.5mm (0.846 in)
Minimum: 8.0mm (0.315 in)
Parts & tools for this job For 1990 Mazda MX-5
- PARTEngine gasket setSearch: Mazda MX-5 1990 engine gasket set
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLFeeler gauge setSearch: feeler gauge set
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.