Pull-out test
- Make
- Mazda
- Model
- MX-5 (NA) Factory Workshop Manual
- Year
- 1990–1992
- Section
- Performance Inspection › Pull-out test
Engine electrical systemPull-out test
Pull-out test
Verify that the pinion is pulled out with 12V connected to the S terminal and the starter body grounded.
Pinion gap check
Measure the pinion gap while the pinion is pulled out.
Specification: 0.5—2.0mm (0.02—0.08 in)
Adjust the pinion gap with an adjustment washer (between drive housing front cover and magnetic switch) if it is not with-in specification.
Return test
- Disconnect the motor wire from the M terminal.
- Connect 12V to the M terminal and ground to the body.
- Pull out the overrunning clutch with a screwdriver. Verify that it returns to its original position when released.
No-load test
- After adjusting the pinion gap, form a test circuit with a volt-meter and an ammeter.
Note
• Use heavy gauge wires and tighten each terminal fully.
- Close switch K to run the starter.
- Check for the following:
| Starter type | kW | 0.95 |
|---|---|---|
| Voltage | V | 11.5 |
| Current | A | Max. 60 |
| Gear shaft speed | rpm | Min. 6,600 |
- If not as specified, check for the cause by referring to In-spection.
Parts & tools for this job For 1990 Mazda MX-5
- PARTEngine gasket setSearch: Mazda MX-5 1990 engine gasket set
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLFeeler gauge setSearch: feeler gauge set
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.