Reassembly
- Make
- Mazda
- Model
- MX-5 (NA) Factory Workshop Manual
- Year
- 1990–1992
- Section
- GI General information › Reassembly
GI General informationReassembly
9MUGIX-040
- Inspection of parts
When removed, each part should be carefully inspected for malfunctioning, deformation, damage, and other problems.
9MUGIX-041
- Arrangement of parts
All disassembled parts should be carefully arranged for reassembly.
Be sure to separate or otherwise identify the parts to be replaced from those that will be reused.
47UOGX-010
- Cleaning parts for reuse
All parts to be reused should be carefully and thoroughly cleaned in the appropriate method.
REASSEMBLY
9MUGIX-004
Standard values, such as torques and certain adjustments, must be strictly observed in the reassembly of all parts. Refer to STANDARD BOLT AND NUT TIGHTENING TORQUE in Section TD for tightening torques not mentioned in the main text.
If removed, these parts should be replaced with new ones:
| 1. Oil seals | 2. Gaskets |
| 3. O-rings | 4. Lock washers |
| 5. Cotter pins | 6. Nylon nuts |
9MUGIX-042
Depending on location:
- Sealant should be applied to gaskets.
- Oil should be applied to the moving components of parts.
- Specified oil or grease should be applied at the prescribed locations (such as oil seals) before reassembly.
Parts & tools for this job For 1990 Mazda MX-5
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLSocket setSearch: socket set metric
- BOOKHaynes manualSearch: Haynes manual Mazda MX-5
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.