Precaution
- Make
- Mazda
- Model
- MX-5 (NA) Factory Workshop Manual
- Year
- 1990–1992
- Section
- Disassembly › Precaution
Manual transmissionPrecaution
Precaution
- Clean the transmission exterior thoroughly with a steam cleaner or cleaning solvent before disassembly.
- Clean the removed parts (except sealed bearings) and all sealing surfaces with cleaning solvent, and dry with compressed air.
Clean out all holes and passages with a compressed air, and check that there are no obstructions. - Wear eye protection when using compressed air to clean components.
Housing Components
Note
● Do not remove the front and rear oil seals if not necessary.
Disassemble in the order shown in the figure, referring to Disassembly Note.
- Release bearing
- Release fork
- Boot
- Front cover
- Gasket
- Oil seal (front)
Inspect for damage of oil seal lip. If necessary, replace it. - Adjustment shim
- Snap ring
- Speedometer driven gear
- Neutral switch
- Back-up light switch
- Extension housing
Disassembly Note
.................... page J–14
Disassembly ..... page J–22 - Transmission case
Disassembly Note
.................... page J–14 - Snap rings
- Speedometer drive gear
- Steel ball
- Oil seal (rear)
Inspect for damage of oil seal lip
If necessary, replace it.
Replace (on-vehicle)
.................... page J–14
Parts & tools for this job For 1990 Mazda MX-5
- PARTClutch kitSearch: Mazda MX-5 1990 clutch kit
- TOOLClutch alignment toolSearch: clutch alignment tool
- FLUIDGear oilSearch: Mazda MX-5 manual gearbox oil
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.