Adjustment shim
- Make
- Mazda
- Model
- MX-5 (NA) Factory Workshop Manual
- Year
- 1990–1992
- Section
- Transmission › Adjustment shim
Adjustment shim
Measure the clearance between the countershaft center bearing and the bearing housing.
If not within specification, adjust the clearance by installing the correct adjustment shim(s).
Standard clearance: 0—0.1mm (0—0.004 in)
Adjustment shim:
0.1mm (0.004 in), 0.3mm (0.012 in)
Mainshaft front bearing
Press the mainshaft front bearing into the bearing housing with a suitable pipe.
Adjustment shim
Measure the clearance between the mainshaft front bearing and the bearing housing.
If not within specification, adjust the clearance by installing the correct adjustment shim(s).
Standard clearance: 0—0.1mm (0—0.004 in)
Adjustment shim:
0.1mm (0.004 in), 0.15mm (0.006 in),
0.3mm (0.012 in)
Reverse idler gear shaft
Press the reverse idler gear into the bearing housing.
Tightening torque:
7.8—11 N·m (80—110 cm-kg, 69—95 in)
Adjustment washer
Measure the clearance between the adjustment washer and snap ring.
If not within specification, adjust the clearance by installing the correct adjustment washer.
Maximum clearance: 0.1mm (0.004 in)
Adjustment washer:
2.6mm (0.102 in), 2.8mm (0.110 in), 3.0mm (0.118 in)
Parts & tools for this job For 1990 Mazda MX-5
- PARTClutch kitSearch: Mazda MX-5 1990 clutch kit
- TOOLClutch alignment toolSearch: clutch alignment tool
- FLUIDGear oilSearch: Mazda MX-5 manual gearbox oil
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.