Power plant frame (PPF)
- Make
- Mazda
- Model
- MX-5 (NA) Factory Workshop Manual
- Year
- 1990–1992
- Section
- Transmission › Power plant frame (PPF)
Manual transmissionPower plant frame (PPF)
Installation note
Transmission
Tilt the engine by pushing up on the front of oil pan with a wooden block and a jack for easy installation of the transmission.
Power plant frame (PPF)
- Install the differential mounting spacer.
Tightening torque:
37—52 N·m (3.8—5.3 m-kg, 27—38 ft-lb)
- Support the transmission with a jack so that it is level.
- Position the PPF and snugly tighten the transmission-side bolts by hand.
- Verify that the sleeve is installed into the block.
Note
• The reamer bolt is installed in the forward hole.
- Install the spacer and bolts, then snugly tighten them.
- Snugly install the power plant frame bracket.
- Tighten the transmission-side bolts.
Tightening torque:
104—123 N·m (10.6—12.6 m-kg, 77—91 ft-lb)
- Tighten the differential-side bolts.
Tightening torque:
104—123 N·m (10.6—12.6 m-kg, 77—91 ft-lb)
Parts & tools for this job For 1990 Mazda MX-5
- PARTClutch kitSearch: Mazda MX-5 1990 clutch kit
- TOOLClutch alignment toolSearch: clutch alignment tool
- FLUIDGear oilSearch: Mazda MX-5 manual gearbox oil
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.