Adjustment of backlash
- Make
- Mazda
- Model
- MX-5 (NA) Factory Workshop Manual
- Year
- 1990–1992
- Section
- Differential › Adjustment of backlash
Front and rear axlesAdjustment of backlash
05U0MX-111
05U0MX-112
Adjustment of backlash
- Check the backlash of the side gears and pinion gears. Adjust by inserting the proper thickness thrust washer at both sides. (Standard)
If not within specification, replace the differential gear as an assembly. (Viscous L.S.D.)
Standard backlash: 0—0.1mm (0—0.004 in)
Thrust washer thickness:
| Identification mark | Thickness |
|---|---|
| 0 | 1.95—2.00mm (0.0768—0.0787 in) |
| 1 | 2.05—2.10mm (0.0807—0.0827 in) |
| 2 | 2.15—2.20mm (0.0846—0.0866 in) |
05U0MX-113
- Install the knock pin to secure the pinion shaft. Stake the pin with a punch to prevent it from coming out of the case.
05U0MX-114
Adjustment of drive pinion and ring gear backlash
Note
• Apply approx. 0.04 cc (0.0024 cu in) of thread-locking compound at each point.
- Apply thread-locking compound to the bolt threads Ⓐand point Ⓑ of the gear back face.
- Install the ring gear onto the gear case.
Tightening torque:
69—83 N·m (7.0—8.5 m-kg, 51—61 ft-lb)
05U0MX-115
- Press the bearing inner races (side bearing) on with the SST.
- Install the differential gear assembly in the carrier.
- Note the identification marks on the adjusting nuts, and install them on their respective sides.
- Install the differential bearing caps, making sure that the identification mark on the cap corresponds with the one on the carrier with the SST.
Parts & tools for this job For 1990 Mazda MX-5
- PARTFront wheel bearingSearch: Mazda MX-5 1990 front wheel bearing
- TOOLBearing puller kitSearch: wheel bearing puller kit
- PARTCV boot kitSearch: Mazda MX-5 1990 cv boot kit
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.