Bearing caps
- Make
- Mazda
- Model
- MX-5 (NA) Factory Workshop Manual
- Year
- 1990–1992
- Section
- Differential › Bearing caps
Front and rear axlesBearing caps
- Heel and face contact
Replace the spacer with a thicker one to bring the drive pinion in.
Bearing caps
- Tighten the bearing cap bolts.
Tightening torque:
68—89 N·m (6.9—9.1 m-kg, 50—66 ft-lb)
- Install the lock plates on the bearing caps.
Tightening torque:
18—25 N·m (1.8—2.6 m-kg, 13—19 ft-lb)
Differential case
- Apply sealant to the housing face.
- Tighten the bolts.
Tightening torque:
23—26 N·m (2.3—2.7 m-kg, 10—20 ft-lb)
Output shaft
Caution
- With viscous L.S.D., the right output shaft is longer than the left shaft.
- Install a new clip.
- Install the output shafts into the side gears by lightly tapping them with a plastic hammer.
- Verify that the output shafts are hooked into the side gears by pulling them by hand.
Parts & tools for this job For 1990 Mazda MX-5
- PARTFront wheel bearingSearch: Mazda MX-5 1990 front wheel bearing
- TOOLBearing puller kitSearch: wheel bearing puller kit
- PARTCV boot kitSearch: Mazda MX-5 1990 cv boot kit
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.