Differential oil
- Make
- Mazda
- Model
- MX-5 (NA) Factory Workshop Manual
- Year
- 1990–1992
- Section
- Differential Oil (M) › Differential oil
Front and rear axlesDifferential oil
DIFFERENTIAL OIL
Inspection
- Remove the filler plug.
- Verify that the oil is at the bottom of the filler plug hole. If it is low, add the specified oil.
- Install the filler plug.
Tightening torque:
39—54 N·m (4.0—5.5 m-kg, 29—40 ft-lb)
Replacement
- Remove the filler and drain plugs.
- Drain the differential oil into a suitable container.
- Wipe the plugs clean.
- Install the drain plug and washer.
Tightening torque:
39—54 N·m (4.0—5.5 m-kg, 29—40 ft-lb)
- Add the specified oil from the filler plug until the level reaches the bottom of the plug hole.
Specified oil
Type:
Above –18°C (0°F): API GL-5, SAE 90
Below –18°C (0°F): API GL-5, SAE 80W
Capacity: 0.65 liter (0.69 US qt, 0.57 Imp qt)
- Install the filler plug.
Tightening torque:
39—54 N·m (4.0—5.5 m-kg, 29—40 ft-lb)
OIL SEAL (OUTPUT SHAFT)
Replacement
- Jack up the vehicle and support it with safety stands.
- Drain the differential gear oil.
Note
- Mark the driveshaft and output shaft flanges for proper reassembly.
- Remove the upper arm installation bolt and nut.
Parts & tools for this job For 1990 Mazda MX-5
- PARTOil filterSearch: Mazda MX-5 1990 oil filter
- TOOLOil filter wrenchSearch: oil filter wrench
- FLUIDEngine oilSearch: Mazda MX-5 engine oil
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.