Inspection
- Make
- Mazda
- Model
- MX-5 (NA) Factory Workshop Manual
- Year
- 1990–1992
- Section
- Inspection (M) › Inspection
Front and rear axlesInspection
Inspection
Wheel bearing play
- Remove the wheel, brake caliper assembly, and disc plate, referring to Removal note below.
- Position a dial indicator against the wheel hub. Push and pull the wheel hub by hand in the axial direction and measure the wheel bearing play.
If the bearing play exceeds specification, check and adjust the locknut torque or replace the wheel bearing if necessary.
Maximum wheel bearing play: 0.05mm (0.002 in)
Removal note
Brake caliper assembly
Note
- For easier installation, do not depress the brake pedal after removing the brake caliper assembly.
Suspend the brake caliper assembly with a rope.
Installation note
Locknut
Install a new locknut and stake it.
Tightening torque:
216—294 N·m (22—30 m·kg, 159—217 ft-lb)
Parts & tools for this job For 1990 Mazda MX-5
- PARTFront wheel bearingSearch: Mazda MX-5 1990 front wheel bearing
- TOOLBearing puller kitSearch: wheel bearing puller kit
- PARTCV boot kitSearch: Mazda MX-5 1990 cv boot kit
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.