Pinion Height Adjustment (M)
- Make
- Mazda
- Model
- MX-5 (NA) Factory Workshop Manual
- Year
- 1990–1992
- Section
- Pinion Height Adjustment (M) › Pinion Height Adjustment (M)
Front and rear axlesPinion Height Adjustment (M)
69G09X-172
05UOMX-102
05UOMX-103
| Mark | Thickness | Mark | Thickness |
|---|---|---|---|
| 08 | 3.08mm (0.1213 in) | 29 | 3.29mm (0.1295 in) |
| 11 | 3.11mm (0.1224 in) | 32 | 3.32mm (0.1307 in) |
| 14 | 3.14mm (0.1224 in) | 35 | 3.35mm (0.1319 in) |
| 17 | 3.17mm (0.1248 in) | 38 | 3.38mm (0.1331 in) |
| 20 | 3.20mm (0.1260 in) | 41 | 3.41mm (0.1343 in) |
| 23 | 3.23mm (0.1271 in) | 44 | 3.44mm (0.1354 in) |
| 26 | 3.26mm (0.1283 in) | 47 | 3.47mm (0.1366 in) |
05UOMX-104
05UOMX-105
7. Place the SST on the surface plate and set the dial indicator to “Zero”. 8. Place the SST atop the drive pinion model. Set the gauge body atop the gauge block. 9. Place the feeler of the dial indicator so that it contacts where the bearing inner race (side bearing) is installed in the carrier. Measure the lowest position on the left and right sides of the carrier. 10. Add the two (left and right) values obtained in Step 9 and divide the total by 2. Specification: 0mm (0 in)Note
• Spacers are available in increments of 0.03mm. Select the spacer thickness that is closest to that necessary.
Note
• Press on until the force required suddenly increases.
• Install the spacer selected for the pinion height adjustment, being careful that the installation direction is correct.
Parts & tools for this job For 1990 Mazda MX-5
- PARTFront wheel bearingSearch: Mazda MX-5 1990 front wheel bearing
- TOOLBearing puller kitSearch: wheel bearing puller kit
- PARTCV boot kitSearch: Mazda MX-5 1990 cv boot kit
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.