Replacement
- Make
- Mazda
- Model
- MX-5 (NA) Factory Workshop Manual
- Year
- 1990–1992
- Section
- Boot › Replacement
Steering systemReplacement
Replacement
- Loosen the wheel lug nuts.
- Jack up the front of the vehicle and support it with safety stands.
- Remove the wheel.
- Remove in the order shown in the figure, referring to Removal Note.
- Install in the reverse order of removal, referring to Installation Note.
After installation, check the steering angle and toe-in and adjust if necessary. (Refer to Section R.)
- Cotter pin
- Nut
- Tie-rod end / Steering knuckle
Removal Note ............ page N– 7 - Locknut
Removal Note ............ page N– 7 - Tie-rod end
- Tie-rod end boot
Removal / Installation Note ....... page N– 7 - Boot clamp
- Boot wire
- Steering gear boot
Parts & tools for this job For 1990 Mazda MX-5
- TOOLTie rod end toolSearch: tie rod end puller
- TOOLBall joint separatorSearch: ball joint separator
- FLUIDPower steering fluidSearch: Mazda power steering fluid
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.