Drive belt
- Make
- Mazda
- Model
- MX-5 (NA) Factory Workshop Manual
- Year
- 1990–1992
- Section
- Drive Belt › Drive belt
Removal note
Pressure pipe
Mark the pressure pipe for reference during installation before loosening.
DRIVE BELT
Inspection
- Check the drive belt for wear, cracks, and fraying. Replace if necessary.
- Check the drive belt deflection by applying mode rate pressure (98 N, 10 kg, 22 lb) midway between the pulleys. Adjust if necessary.
Deflection (Depressed at 98 N [10 kg, 22 lb])
New : 8—9mm (0.31—0.35 in)
Used: 9—10mm (0.35—0.39 in)
Tension
New : 491—589 N (50—60 kg, 110—132 lb)
Used: 422—491 N (43—50 kg, 95—110 lb)
Note
• Belt tension can be measured between any pulleys.
Adjustment
- Loosen P/S oil pump bolt A and nuts B and C. Adjust the belt deflection by turning the adjusting bolt D.
Tightening torque:
A: 31—46 N·m (3.2—4.7 m-kg, 23—34 ft-lb)
B: 36—54 N·m (3.7—5.5 m-kg, 27—40 ft-lb)
C: 19—25 N·m (1.9—2.6 m-kg, 14—19 ft-lb)
Replacement
- Lossen bolt A, nuts B and C, and adjusting bolt D.
- Remove and replace the drive belt.
- Adjust the deflection (tension). (Refer to above.)
Parts & tools for this job For 1990 Mazda MX-5
- TOOLTie rod end toolSearch: tie rod end puller
- TOOLBall joint separatorSearch: ball joint separator
- FLUIDPower steering fluidSearch: Mazda power steering fluid
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.