Fluid pressure
- Make
- Mazda
- Model
- MX-5 (NA) Factory Workshop Manual
- Year
- 1990–1992
- Section
- Fluid pressure › Fluid pressure
Steering systemFluid pressure
Note
• Before disconnecting the hose, make marks at the connections for proper reinstallation.
- Disconnect the high-pressure hose from the oil pump. Attach the SST.
- Bleed the air from the system. (Refer to page N–15.)
- Open the gauge valve fully. Start the engine and turn the steering wheel fully left and right to raise the fluid temperature to 50—60°C (122—140°F).
Caution
• If the valve is left closed for more than 15 seconds, the fluid temperature will increase excessively and adversely affect the oil pump.
- Close the gauge valve completely. Increase the engine speed to 1,000—1,500 rpm and measure the fluid pressure generated by the oil pump. If the pressure is not within specification, replace the oil pump assembly.
Oil pump fluid pressure: 7,603—8,339 kPa (77.5—85.0 kg/cm², 1,102—1,209 psi)
- Open the gauge valve fully and increase the engine speed to 1,000—1,500 rpm.
Parts & tools for this job For 1990 Mazda MX-5
- TOOLTie rod end toolSearch: tie rod end puller
- TOOLBall joint separatorSearch: ball joint separator
- FLUIDPower steering fluidSearch: Mazda power steering fluid
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.