Removal / Installation
- Make
- Mazda
- Model
- MX-5 (NA) Factory Workshop Manual
- Year
- 1990–1992
- Section
- Removal / Installation › Removal / Installation
Steering systemRemoval / Installation
Removal / Installation
Caution
Disconnect/connect the pinion shaft from/to the intermediate shaft with the wheels in the straight-ahead position, and do not turn the steering wheel while the steering gear is removed. If not done correctly, adjust the clockspring connector. (U.S. spec.) (Refer to Section T.)
- Loosen the wheel lug nuts.
- Jack up the front of the vehicle and support it with safety stands.
- Remove the wheels.
- Remove in the order shown in the figure, referring to Removal Note.
Note
Use a container or rags to collect the power steering fluid when disconnecting the pressure pipe and return hose.
- Install in the reverse order of removal, referring to Installation Note.
- Tighten all necessary bolts and nuts to the specified torque.
- After installation:
- Check for fluid leakage. (Refer to page N–16.)
- Bleed air from the system. (Refer to page N–15.)
- Cotter pin
- Nut
- Tie-rod end
Removal Note .......................... page N– 7 - Bolt
- Pressure pipe
Removal Note .......................... page N–20 - Return hose
- Mounting bracket bolt
- Steering gear and linkage
Parts & tools for this job For 1990 Mazda MX-5
- TOOLTie rod end toolSearch: tie rod end puller
- TOOLBall joint separatorSearch: ball joint separator
- FLUIDPower steering fluidSearch: Mazda power steering fluid
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.