Inspection
- Make
- Mazda
- Model
- MX-5 (NA) Factory Workshop Manual
- Year
- 1990–1992
- Section
- Steering column › Inspection
Disassembly note
Steering lock mounting bolts and bracket
Use a chisel to make a groove in the heads of the steering lock mounting bolts. Remove the bolts with a screwdriver. Remove the steering lock assembly.
Inspection
Check for the following and replace the column assembly if necessary.
Steering shaft
- Column bearing damage.
- Steering shaft length.
Length: 583.3 ± 1.5mm (22.96 ± 0.06 in)
Assembly note
Steering lock mounting bolts and bracket
Install the steering lock assembly on the jacket. Install the new steering lock mounting bolts. Tighten the bolts until the heads break off.
Parts & tools for this job For 1990 Mazda MX-5
- TOOLTie rod end toolSearch: tie rod end puller
- TOOLBall joint separatorSearch: ball joint separator
- FLUIDPower steering fluidSearch: Mazda power steering fluid
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.