Troubleshooting guide (Cont’d)
- Make
- Mazda
- Model
- MX-5 (NA) Factory Workshop Manual
- Year
- 1990–1992
- Section
- Troubleshooting guide (Cont’d) › Troubleshooting guide (Cont’d)
Steering systemTroubleshooting guide (Cont’d)
| Problem | Possible Cause | Action | Page/Section |
|---|---|---|---|
| General instability while driving | Incorrect tire pressure | Adjust | Section Q |
| Damaged or unbalanced wheel | Adjust or replace | Section Q | |
| Worn or damaged steering joint(s) | Replace | N– 9 | |
| Improper steering pinion preload | Replace gear | N–19 | |
| Weak front coil spring | Replace | Section R | |
| Worn or damaged stabilizer and/or upper or lower arm bushing | Replace | Section R | |
| Malfunctioning shock absorber | Replace | Section R | |
| Improperly adjusted wheel alignment | Adjust | Section R | |
| Shake (Steering wheel vibrates up/down) |
Excessive tire and/or wheel runout | Replace | Section Q |
| Loose lug nuts | Tighten | Section Q | |
| Unbalanced wheel(s) | Adjust or replace | Section Q | |
| Cracked or worn engine mount rubber | Replace | Section B | |
| Cracked or worn transmission mount rubber | Replace | Section J | |
| Shimmy (Steering wheel vibrates left/right) |
Cracked or worn steering gear mount rubber | Replace | N–19 |
| Loose steering gear mounting bolts | Tighten | N–19 | |
| Stuck or damaged steering ball joint | Replace | N–19 | |
| Excessive tire and/or wheel runout | Replace | Section Q | |
| Loose lug nuts | Tighten | Section Q | |
| Unbalanced wheel(s) | Adjust or replace | Section Q | |
| Incorrect tire pressure | Adjust | Section Q | |
| Unevenly worn tires | Replace | Section Q | |
| Malfunctioning shock absorber | Replace | Section R | |
| Loose shock absorber mounting bolts | Tighten | Section R | |
| Stuck or damaged lower arm ball joint | Replace | Section R | |
| Cracked or worn suspension bushings | Replace | Section R | |
| Damaged or worn front wheel bearing | Replace | Section M | |
| Excessive steering wheel play | Improperly adjusted front wheel alignment | Adjust | Section R |
| Worn steering gear | Replace | N–19 | |
| Worn or damaged steering joints | Replace | N– 9 | |
| Worn or damaged lower arm bushing | Replace | Section R | |
| Loose steering gear mounting bolts | Tighten | N–19 | |
| Worn linkage or tie-rod ball joint | Replace | N–19 | |
| Poor steering wheel return | Incorrect tire pressure | Adjust | Section Q |
| Stuck or damaged steering joints | Replace | N– 9 | |
| Improperly adjusted front wheel alignment | Adjust | Section R | |
| Improper steering pinion preload | Replace gear | N–19 | |
| Ball joint not operating smoothly | Replace | N–19 | |
| Steering shaft contacting something | Repair | N– 9 | |
| Abnormal noise from steering system | Loose oil pump | Tighten | N–21 |
| Loose steering gear | Tighten | N–19 | |
| Loose oil pump bracket | Tighten | Section B | |
| Drive belt loose/tight | Adjust | N–22 | |
| Air in system | Bleed air | N–15 | |
| Malfunctioning steering gear | Replace | N–19 | |
| Malfunctioning oil pump | Replace | N–21 | |
| Obstruction near steering column or pressure hose | Repair or replace | N– 9 | |
| Loose steering linkage | Tighten or replace | N–19 | |
| Worn steering joints | Replace | N– 9 |
Parts & tools for this job For 1990 Mazda MX-5
- TOOLTie rod end toolSearch: tie rod end puller
- TOOLBall joint separatorSearch: ball joint separator
- FLUIDPower steering fluidSearch: Mazda power steering fluid
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.