Removal / Inspection / Installation
- Make
- Mazda
- Model
- MX-5 (NA) Factory Workshop Manual
- Year
- 1990–1992
- Section
- Upper arm › Removal / Inspection / Installation
SuspensionRemoval / Inspection / Installation
Removal / Inspection / Installation
- Jack up the rear of the vehicle and support it with safety stands.
- Remove in the order shown in the figure, referring to Removal Note.
- Inspect all parts and repair or replace as necessary.
- Install in the reverse of removal.
Note
- Loosely tighten the upper arm bolts. Lower the vehicle and tighten all nuts and bolts to the specified torques with the vehicle unladed.
Adjust the rear wheel alignment. (Refer to page R–9.)
- Upper arm
Inspect for damage and cracks - Upper arm bushing
Inspect for deterioration and wear
Parts & tools for this job For 1990 Mazda MX-5
- TOOLCoil spring compressorSearch: coil spring compressor
- TOOLBall joint separatorSearch: ball joint separator
- PARTShock absorbersSearch: Mazda MX-5 1990 shock absorbers
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.