Hardening time of repair seal
- Make
- Mazda
- Model
- MX-5 (NA) Factory Workshop Manual
- Year
- 1990–1992
- Section
- S Body › Hardening time of repair seal
BodyHardening time of repair seal · page 1 of 2
- Bond a new dam along the circumference of the glass 7mm (0.28 in) from the edge.
Caution
- Bond the dam securely and allow it to dry.
- Install the spacers onto the body as shown.
Caution
- Damaged spacers must be replaced.
- Prepare the nozzle of the sealant tube so that it has a flange that can run along the edge of the glass and a V from which the sealant can flow. Once the primer is dry, apply repair seal (B001 77 739) around the entire circumference to fill the gap between the dam and the edge of the glass with a ridge of sealant 11mm (0.43 in) high. Keep the bead of sealant smooth and even, reshaping it where necessary with a spatula.
- If the protector is damaged, bond a new protector onto the body, as shown.
Caution
- Bond the protector securely and allow it to dry.
- Install the glass, aligning the glass mark with the V notch in the spacer. Push it in lightly toward the vehicle to compress the sealant.
Caution
- Lower the convertible top to prevent the glass from being pushed out by air pressure if a door is closed.
Hardening time of repair seal
| Temperature | Surface hardening time | Time required until car can be put into service |
|---|---|---|
| 5°C (41°F) | Approx. 1.5 hr | 12 hr |
| 20°C (68°F) | Approx. 1 hr | 4 hr |
| 35°C (95°F) | Approx. 10 min | 2 hr |
Parts & tools for this job For 1990 Mazda MX-5
- TOOLTrim removal tool kitSearch: trim removal tool kit
- PARTTouch-up paintSearch: Mazda touch up paint
- PARTPanel clip assortmentSearch: Mazda panel clips assortment
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.