Hardening time of repair seal
- Make
- Mazda
- Model
- MX-5 (NA) Factory Workshop Manual
- Year
- 1990–1992
- Section
- S Body › Hardening time of repair seal
BodyHardening time of repair seal · page 1 of 2
- Bond a new dam along the circumference of the glass 8mm (0.31 in) from the edge.
Caution
- Bond the dam securely and allow it to dry.
- Prepare the nozzle of the sealant tube so that it has a flange that can run along the edge of the glass and a V from which the sealant can flow. Once the primer is dry, apply the sealant around the entire circumference to fill the gap between the dam and the edge of the glass with a ridge of sealant 11mm (0.43 in) high.
Keep the bead of sealant smooth and even, reshaping it where necessary with a spatula.
- If protector is damaged bond a new protector onto the detachable hard top, as shown.
Caution
- Bond the protector securely and allow it to dry.
- Align the studs of the glass with the detachable hard top and mount the glass.
- Push the glass lightly toward the front to compress the sealant.
- Tighten the glass mounting nuts.
Tightening torque:
2.4—3.3 N·m (24—34 cm-kg, 20.8—29.5 in-lb)
- Use a scraper to smooth away any sealant that oozes out. Add more sealant to any points of poor contact.
- Install the new rear window molding. (Refer to page S–29.)
Hardening time of repair seal
| Temperature | Surface hardening time | Time required until car can be put into service |
|---|---|---|
| 5°C (41°F) | Approx. 1.5 hr | 12 hr |
| 20°C (68°F) | Approx. 1 hr | 4 hr |
| 35°C (95°F) | Approx. 10 min | 2 hr |
Parts & tools for this job For 1990 Mazda MX-5
- TOOLTrim removal tool kitSearch: trim removal tool kit
- PARTTouch-up paintSearch: Mazda touch up paint
- PARTPanel clip assortmentSearch: Mazda panel clips assortment
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.