Clock Spring Connector Assembly
- Make
- Mazda
- Model
- MX-5 (NA) Factory Workshop Manual
- Year
- 1990–1992
- Section
- Clock Spring Connector Assembly › Clock Spring Connector Assembly
Body electrical systemClock Spring Connector Assembly
Clock Spring Connector Assembly
Note
- The clock spring connector assembly is part of the combination switch. When replacing the clock spring connector assembly, replace it with the combination switch as an assembly.
- Disconnect the negative battery cable.
- Remove the knee protector, and disconnect the clock spring and combination switch connectors.
- Remove the nuts and remove the air bag module.
(Refer to page T–150.)
Caution
- Do not strike the steering shaft with a hammer; the collapsible shaft may collapse.
- Remove the nut and remove the steering wheel with a steering wheel puller.
- Remove the screws and column cover.
- Loosen the screws and remove the clock spring connector assembly with the combination switch.
Parts & tools for this job For 1990 Mazda MX-5
- TOOLCoil spring compressorSearch: coil spring compressor
- TOOLBall joint separatorSearch: ball joint separator
- PARTShock absorbersSearch: Mazda MX-5 1990 shock absorbers
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.