Warning
- Make
- Mazda
- Model
- MX-5 (NA) Factory Workshop Manual
- Year
- 1990–1992
- Section
- Description (U.S. spec.) › Warning
The headlight system consists of two halogen headlights mounted on retractable mechanisms, a headlight switch in the combination switch, and a retractor switch between the center ventilation outlets.
When the headlight switch is rotated to the second position, the headlights are activated and the headlight retractor motors lift the headlights. If only the retractor switch is turned ON, the headlights will raise to the upright position, but all lights will be off.
An emergency manual retractor knob is located atop each headlight retractor motor.
Warning
- When using the manual control knob, the negative battery cable must be disconnected to prevent accidental movement of the headlight and possible injury.
05U0TX-085
Troubleshooting
F1 Symptom: Headlights do not operate. (U.S. spec.)
05U0TX-086
Step 1
- Check HEAD 30A fuse in the main fuse block.
- If the fuse is burned, replace it. Check and repair the wiring harness, if necessary.
- If the fuse is OK, go to Step 2.
05U0TX-295
Step 2
- Turn the headlight switch ON.
- Measure the voltage at the following terminal-wires of the headlight relay connector.
| Terminal-wire | Voltage | Action |
|---|---|---|
| (W/B) | 12V | Go to Step 3 |
| 0V | Next check wire (L/Y) | |
| (L/Y) | 12V | Go to Step 6 |
| 0V | Next check wire (R/L) | |
| (R/L: Terminal A) | 12V | Next check wire (R/L) |
| 0V | Repair wire (R/L) (HEAD 30A—Headlight relay) |
|
| (R/L: Terminal D) | 12V | Replace headlight relay |
| 0V | Repair wire (R/L) (HEAD 30A—Headlight relay) |
05U0TX-087
Parts & tools for this job For 1990 Mazda MX-5
- TOOLDigital multimeterSearch: automotive digital multimeter
- PARTAssorted fuse kitSearch: car fuse assortment kit
- TOOLWire crimper and connector kitSearch: wire crimper connector kit
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.