Step 1
- Make
- Mazda
- Model
- MX-5 (NA) Factory Workshop Manual
- Year
- 1990–1992
- Section
- Flowchart No. 7 (T) › Step 1
Body electrical systemStep 1
Caution
• Before troubleshooting, read SERVICE PRECAUTION on page T–133.
Step 1
- Disconnect the negative battery cable.
- Remove the knee protector, and disconnect the clock spring connectors (Orange and blue).
- Disconnect the diagnostic module connector.
- Check continuity between the following terminals of the diagnostic module connector and a body ground.
| Terminal-wire | Continuity | Action |
|---|---|---|
| 2J (BR/Y)—Body ground | Yes | Next, check between 2H (BR/W) and body ground |
| No | Go to Step 2 | |
| 2H (BR/W)—Body ground | Yes | Next, check between 2E (BR) and body ground |
| No | Go to Step 3 | |
| 2E (BR)—Body ground | Yes | Replace diagnostic module |
| No | Go to Step 4 |
Step 2
- Disconnect the D-sensor (RH) connectors, and check continuity between terminals of the sensor connectors and a body ground.
| Terminal | Continuity |
|---|---|
| b—Body ground | Yes |
- If not as specified, go to Step 5.
- If correct, replace the wire harness assembly.
Step 3
- Disconnect the D-sensor (CNT) connectors, and check continuity between terminals of the sensor connector and a body ground.
| Terminal | Continuity |
|---|---|
| b—Body ground | Yes |
- If not as specified, go to Step 5.
- If correct, replace the wire harness assembly.
Parts & tools for this job For 1990 Mazda MX-5
- TOOLDigital multimeterSearch: automotive digital multimeter
- PARTAssorted fuse kitSearch: car fuse assortment kit
- TOOLWire crimper and connector kitSearch: wire crimper connector kit
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.