6. When Using Test Lead
- Make
- Mazda
- Model
- MX-5 (NA) Factory Workshop Manual
- Year
- 1990–1992
- Section
- T Body electrical system › 6. When Using Test Lead
Body electrical system6. When Using Test Lead
- Align the marks on the clock spring connector and the outer housing.
6. When Using Test Lead
- When using a test lead for testing, use a fine needle to prevent damage to the terminal.
7. Disconnecting Double Lock Type Connector
- The connectors in the air bag system use a double lock type connector.
- These connectors are disconnected as below.
- Press the orange knob and disconnect the orange connector.
- Press the blue knob and disconnect the blue connector.
- Connect the connectors in the reverse order of disconnecting.
8. After System Service
- After system service verify system operation by checking with the air bag system warning lamp. If the system is operating normally, the warning lamp will come on when the ignition switch is turned ON, then go off after approximately 6 seconds.
- Check if the horn sounds. If the horn does not sound, remove the air bag module and check the connections of the air bag module and horn switch connectors.
Parts & tools for this job For 1990 Mazda MX-5
- TOOLDigital multimeterSearch: automotive digital multimeter
- PARTAssorted fuse kitSearch: car fuse assortment kit
- TOOLWire crimper and connector kitSearch: wire crimper connector kit
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.