Inspection
- Make
- Mazda
- Model
- MX-5 (NA) Factory Workshop Manual
- Year
- 1990–1992
- Section
- Inspection › Inspection
Body electrical systemInspection
INSPECTION
D-sensor (LH)
- Disconnect the negative battery cable.
- Remove the knee protector, and disconnect the clock spring connectors (Orange and blue).
- Remove the bolts and the relay box.
- Disconnect the D-sensor (LH) connector.
Caution
• Do not connect an ohmmeter to the harness side connector.
Connect the ohmmeter to the sensor side connectors only.
- Measure resistance between the terminals of the sensor connectors.
| Terminals | Resistance |
|---|---|
| a (blue)—b (orange) | Approx. 1.2 kΩ |
- If not as specified, replace the sensor.
Caution
• Do not try to repair the wire harness.
D-sensor (RH)
- Disconnect the negative battery cable.
- Remove the knee protector, and disconnect the clock spring connectors (Orange and blue).
- Remove the bolts and the main fuse block.
- Disconnect the D-sensor (RH) connector.
Caution
• Do not connect an ohmmeter to the harness side connector.
Connect the ohmmeter to the sensor side connectors only.
- Measure resistance between the terminals of the sensor connectors.
| Terminals | Resistance |
|---|---|
| a (blue)—b (orange) | Approx. 1.2 kΩ |
- If not as specified, replace the sensor.
Caution
• Do not try to repair the wire harness.
Parts & tools for this job For 1990 Mazda MX-5
- TOOLDigital multimeterSearch: automotive digital multimeter
- PARTAssorted fuse kitSearch: car fuse assortment kit
- TOOLWire crimper and connector kitSearch: wire crimper connector kit
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.