Steering lock
- Make
- Mazda
- Model
- MX-5 (NA) Factory Workshop Manual
- Year
- 1990–1992
- Section
- Switch › Steering lock
Body electrical systemSteering lock
STEERING LOCK
Replacement
- Disconnect the negative battery cable.
- Remove the column covers.
- Remove the screw and the ignition switch.
- Install in the reverse order of removal.
Inspection
- Check continuity between terminals of the switch.
| Position | Terminal | |||||||
|---|---|---|---|---|---|---|---|---|
| B1 | B2 | ACC | IG1 | IG2 | ST | K1 | K2 | |
| LOCK | ○—○ | |||||||
| ACC | ○—○ | ○—○ | ||||||
| ON | ○—○ | ○ | ○ | ○ | ○ | ○—○ | ||
| START | ○—○ | ○ | ○ | ○ | ○—○ | |||
○—○: Indicates continuity
- If not as specified, replace the combination switch.
COMBINATION SWITCH
Removal / Installation
Caution (U.S. spec.)
• Before removing the clock spring connector, disconnect the negative battery cable.
• Before installing the steering wheel, reset the clock spring connector. (Refer to page T–22.)
Remove and install as shown in the figure.
Canada spec.
Parts & tools for this job For 1990 Mazda MX-5
- TOOLTie rod end toolSearch: tie rod end puller
- TOOLBall joint separatorSearch: ball joint separator
- FLUIDPower steering fluidSearch: Mazda power steering fluid
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.