Remady
- Make
- Mazda
- Model
- MX-5 (NA) Factory Workshop Manual
- Year
- 1990–1992
- Section
- Troubleshooting › Remady
Body electrical systemRemady
Symptom: Illumination lamp control does not operate.
Remady
- Turn the headlight switch ON.
- Set the panel lamp control switch to Max. position.
- Measure the voltage at the following terminal wires of the panel lamp control switch connector.
| Wire | Voltage | Action |
|---|---|---|
| (B) | 0V | Next check wire (R/B) |
| Other 0V | Repair wire (B) (Panel lamp control switch — Body ground) | |
| (R/B) | 12V | Next check wire (R) |
| 0V | Repair wire (R/B) (TAIL 15A fuse — Panel lamp control switch) | |
| (R) | 0V | Repair wiring harness (Panel lamp control switch — Each lamp) |
| Other 0V | Replace panel lamp control switch |
Inspection
Panel lamp control switch
- Remove the panel lamp control switch.
- Apply 12V to terminal d and ground terminal g.
- Check that the voltage at terminal a changes linealy when turning the control switch.
| Switch | Voltage |
|---|---|
| Min. position | 10V |
| Max. position | 0V |
- If not as specified, replace the panel lamp control switch.
Parts & tools for this job For 1990 Mazda MX-5
- TOOLDigital multimeterSearch: automotive digital multimeter
- PARTAssorted fuse kitSearch: car fuse assortment kit
- TOOLWire crimper and connector kitSearch: wire crimper connector kit
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.