Step 1
- Make
- Mazda
- Model
- MX-5 (NA) Factory Workshop Manual
- Year
- 1990–1992
- Section
- Troubleshooting › Step 1
Body electrical systemStep 1
F1 Symptom: No lights illuminate (taillights, side marker lights, and license plate lights). (U.S. spec.)




Step 1
- Check TAIL 15A.
- If the fuse is burned, replace it. Check and, if necessary, repair the wiring harness.
- If the fuses are OK, go to Step 2.
Step 2
- Turn the headlight switch ON.
- Measure the voltage at the following terminal wires of the TNS relay connector.
| Wire | Voltage | Action |
|---|---|---|
| (W/L) | 12V | Go to Step 3 |
| 0V | Next check wire (LG) | |
| (LG) | 12V | Go to Step 4 |
| 0V | Next check wire (W/R: Terminal a) | |
| (W/R) Terminal a | 12V | Next check wire (W/R: Terminal b) |
| 0V | Repair wire (W/R) (TAIL 15A fuse — TNS relay) |
|
| (W/R) Terminal b | 12V | Replace TNS relay |
| 0V | Repair wire (W/R) (TAIL 15A fuse — TNS relay) |
Step 3
- Check the bulbs of the each light.
- If the bulb is burned, replace the bulb.
- If the bulbs are OK, repair wiring harness between the TNS relay and the body ground of each light.
Step 4
- Disconnect the negative battery cable.
- Remove the knee protector.
- Disconnect the combination switch connector.
- Check continuity between the following terminals of the combination switch.
| Position | E | HL | HU | TNS | HEAD | BA | B | |
|---|---|---|---|---|---|---|---|---|
| Headlight | Low beam | |||||||
| High beam | ||||||||
| Passing | ||||||||
| Taillights, Parking | ||||||||
| —: Indicates continuity | ||||||||
- If not as specified, replace the combination switch.
- If correct, repair the wiring harness. (TNS relay — combination switch)
Parts & tools for this job For 1990 Mazda MX-5
- TOOLDigital multimeterSearch: automotive digital multimeter
- PARTAssorted fuse kitSearch: car fuse assortment kit
- TOOLWire crimper and connector kitSearch: wire crimper connector kit
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.