Troubleshooting Procedure
- Make
- Mazda
- Model
- MX-5 (NA) Factory Workshop Manual
- Year
- 1990–1992
- Section
- Troubleshooting guide › Troubleshooting Procedure
Troubleshooting Procedure
Troubleshooting of the air bag system is performed using the coded flashing of the air bag system warning lamp. The number of times the the warning lamp flashes is based on the type of fault being detected. Codes are prioritized in such a way that if two or more faults occur at the same time, the highest priority fault indication will dominate until corrected.
Note
• When the ignition switch is turned ON, an audible alarm may be heard. If so, it indicates a simultaneous warning lamp failure and a problem in the air bag system.
05OUTX-365
Flash code table
| Priority | Flash code | Possible cause | Flowchart No. |
|---|---|---|---|
| 1 | Remains ON | Faulty diagnostic module or poor connection of diagnostic module connector | 1 (See page T–139) |
| 2 | Flashes three times | Open circuit or poor connection of power source circuit | 2 (See page T–140) |
| 3 | Flashes five times | Faulty D-sensor (D-sensor remains ON) | 3 (See page T–142) |
| 4 | Flashes ten times | Faulty diagnostic module (System-down fuse burned) | 4 (See page T–143) |
| 5 | Flashes four times | Faulty S-sensor | 5 (See page T–144) |
| 6 | Flashes six times | Faulty air bag module or poor connection of clock spring connector | 6 (See page T–146) |
| 7 | Flashes eight times | Poor ground of D-sensor | 7 (See page T–148) |
| 8 | Flashes nine times | Open circuit between diagnostic module and D-sensor | 3 (See page T–142) |
| 9 | Flashes two times | Poor ground of all D-sensors | 7 (See page T–148) |
05U0TX-366
Parts & tools for this job For 1990 Mazda MX-5
- TOOLDigital multimeterSearch: automotive digital multimeter
- PARTAssorted fuse kitSearch: car fuse assortment kit
- TOOLWire crimper and connector kitSearch: wire crimper connector kit
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.