Step 8
- Make
- Mazda
- Model
- MX-5 (NA) Factory Workshop Manual
- Year
- 1990–1992
- Section
- Troubleshooting (T) › Step 8
Body electrical systemStep 8
Step 8
Measure the voltage at the terminal-wires of the DRL connector as shown.
| Wire | Condition | Voltage | Action |
|---|---|---|---|
| (G/W) | Turn signal switch right position | 12V | Next, check wire (G/Y) |
| 0V | Repair wire (G/W) (Flasher unit—DRL unit) | ||
| (G/Y) | 12V | Repair wire (G/Y) (DRL unit—Bulb) | |
| 0V | Check DRL unit (Refer to page T–18) | ||
| (G/B) | Turn signal switch left position | 12V | Next, check wire (G/O) |
| 0V | Repair wire (G/O) (Flasher unit—DRL unit) | ||
| (G/O) | 12V | Repair wire (G/O) (DRL unit—Bulb) | |
| 0V | Check DRL unit (Refer to page T–18) |
Symptom: Turn signal(s) flashes rapidly.
Remedy
Check the bulbs and the wiring harness between each bulb and the body ground (rapidly flashing side).
Note
- Rapid flashing is a flasher unit function to warn of a bad bulb or an open circuit.
Parts & tools for this job For 1990 Mazda MX-5
- TOOLDigital multimeterSearch: automotive digital multimeter
- PARTAssorted fuse kitSearch: car fuse assortment kit
- TOOLWire crimper and connector kitSearch: wire crimper connector kit
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.