Inspection
- Make
- Mazda
- Model
- MX-5 (NA) Factory Workshop Manual
- Year
- 1990–1992
- Section
- Disassembly / Assembly › Inspection
Heater and air conditioner systemsInspection
Disassemble and assemble as shown in the figure.
- Blower motor
- Resistor assembly
- REC-FRESH door
Inspection
Blower motor
- Verify that the blower motor runs when connecting 12V to terminal a and grounding terminal b.
- If the blower motor does not run, replace it.
Resistor assembly
- Check for continuity between terminals of the resistor assembly.
| Terminals | Continuity |
|---|---|
| C—Lo | Yes |
| C—Me | Yes |
| C—Mh | Yes |
| C—Hi | Yes |
Note
• Set the ohmmeter to the x1,000 range.
- If not as specified, replace the resistor assembly.
Parts & tools for this job For 1990 Mazda MX-5
- TOOLA/C manifold gauge setSearch: AC manifold gauge set
- TOOLUV leak detection kitSearch: AC UV leak detection kit
- PARTCabin filterSearch: Mazda MX-5 1990 cabin filter
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.