Step 1
- Make
- Mazda
- Model
- MX-5 (NA) Factory Workshop Manual
- Year
- 1990–1992
- Section
- U Heater and air conditioner systems › Step 1
Case 4: Moisture in system
Measured pressure
Low-pressure side: 50 cmHg (2.0 inHg): [Vacuum]
High-pressure side: 687—1,472 kPa (7—15 kg/cm², 100—213 psi)
Condition
Intermittent cooling
(Moisture in refrigeration system freezes in expansion valve and causes temporary blocking. After time, ice melts and condition returns to normal.)
Step 1
Discharge the refrigeration system. (Refer to page U–28.)
Step 2
Evacuate the system to remove all air and moisture from it. (Refer to page U–29.)
Step 3
Charge the system with refrigerant. (Refer to page U–28.)
Step 4
After charging, measure the refrigerant pressure. (Refer to page U–31.)
Step 5
If low- and high-pressure sides are still too high, replace the receiver/drier.
Case 5: No refrigerant circulation
Measured pressure
Low-pressure side: 76 cmHg (3.0 inHg) [Vacuum]
High-pressure side: Below 589 kPa (6 kg/cm², 85 psi)
Condition
Refrigerant flow obstructed by moisture or dirt, causing freezing or blockage of expansion valve
Step 1
Turn the air conditioner OFF for about 10 minutes. Turn the air conditioner ON to determine whether the blockage is due to moisture or dirt.
a) If caused by moisture
System will operate normally after being OFF for 10 minutes.
(Ice melts and relieves blockage.)
Refer to “Moisture in system”.
b) If caused by dirt
System remains abnormal after being OFF 10 minutes.
Go to Step 2.
Step 2
- Remove the expansion valve. (Refer to page U–33.)
- Blow out the dirt with compressed air.
- If unable to remove the dirt, replace the expansion valve.
- Evacuate, charge, and test the system.
Parts & tools for this job For 1990 Mazda MX-5
- TOOLA/C manifold gauge setSearch: AC manifold gauge set
- TOOLUV leak detection kitSearch: AC UV leak detection kit
- PARTCabin filterSearch: Mazda MX-5 1990 cabin filter
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.