Thermoswitch
- Make
- Mazda
- Model
- MX-5 (NA) Factory Workshop Manual
- Year
- 1990–1992
- Section
- On-vehicle Inspection › Thermoswitch
Heater and air conditioner systemsThermoswitch
On-vehicle Inspection
Thermoswitch
- Remove the glove box.
- Run the engine at idle.
- Turn OFF the A/C switch and set the blower switch to the highest position to operate the blower fan for a few minutes.
- After a few minutes, turn OFF the blower switch and stop the engine.
- Disconnect the thermoswitch connector and check for continuity between terminals of the switch.
| Terminals | Continuity |
|---|---|
| a—b | Yes |
- If not as specified, replace the thermoswitch.
Note
• The thermoswitch contacts will be open if the evaporator temperature is below 0°C (32°F).
Inspection
Thermoswitch
- Immerse the sensing bulb in a container of ice water.
- Check continuity between terminals of the switch as specified.
| Terminals | Temperature | Continuity |
|---|---|---|
| a—b | Above 0°C (32°F) | Yes |
| Below 0°C (32°F) | No |
- If not as specified, replace the thermoswitch.
Evaporator
- Check the evaporator fins for blockage. If the fins are clogged, clean them with compressed air.
Caution
• Never use water to clean the evaporator.
- Check the fittings for cracks and other damage. Replace the evaporator if necessary.
Parts & tools for this job For 1990 Mazda MX-5
- TOOLA/C manifold gauge setSearch: AC manifold gauge set
- TOOLUV leak detection kitSearch: AC UV leak detection kit
- PARTCabin filterSearch: Mazda MX-5 1990 cabin filter
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.