Workshop Manuals Factory service & repair Mazda
01 General information02 Engine03 Engine performance04 Transmission05 Driveline and axles06 Suspension07 Brakes08 Steering09 Restraints10 Heating and air conditioning11 Electrical12 Accessories and equipment13 Body and cab accessories
Mazda MX-5 (NC) Factory Workshop Manual (2006-2008)13 · Body and cab accessories
13 · Body & interior

Hood adjustment

Make
Mazda
Model
MX-5 (NC) Factory Workshop Manual
Year
2006–2008
Section
Body Panels › Hood adjustment
Body and cab accessoriesHood adjustment

HOOD ADJUSTMENT

GAP ADJUSTMENT

  1. Disconnect the negative battery cable. (See BATTERY REMOVAL/INSTALLATION [LF] .)
  2. Remove the following parts:
  3. Front bumper (See FRONT BUMPER REMOVAL/INSTALLATION .)
  4. Front combination lights (See FRONT COMBINATION LIGHT REMOVAL/INSTALLATION .)
  5. Side step molding (See SIDE STEP MOLDING REMOVAL .) (See SIDE STEP MOLDING INSTALLATION .)
  6. Front fender panel (See FRONT FENDER PANEL REMOVAL/INSTALLATION .)
  7. Loosen the hood hinge installation bolts and adjust the hood.
  8. Tighten the bolts.
ACCESSORIES & BODY, CAB – Body Panels – figure
Fig. 14: Adjusting Hood Hinge
Courtesy of MAZDA MOTORS CORP.
  1. Verify that the gap between the hood and the body is within the specification.

Standard clearance

a. 3.5-6.5 mm {0.14-0.25 in}

Parts & tools for this job For 2006 Mazda MX-5

As an Amazon Associate we earn from qualifying purchases.