Workshop Manuals Factory service & repair Mazda
01 General information02 Engine03 Engine performance04 Transmission05 Driveline and axles06 Suspension07 Brakes08 Steering09 Restraints10 Heating and air conditioning11 Electrical12 Accessories and equipment13 Body and cab accessories
Mazda MX-5 (NC) Factory Workshop Manual (2006-2008)13 · Body and cab accessories
13 · Body & interior

Diagnostic procedure

Make
Mazda
Model
MX-5 (NC) Factory Workshop Manual
Year
2006–2008
Section
Symptom Troubleshooting › Diagnostic procedure
Body and cab accessoriesDiagnostic procedure
  • Fuel gauge sender unit is improperly installed

POSSIBLE

  • Open or short circuit in wiring harness between instrument cluster and GND

CAUSE

  • Open or short circuit in wiring harness between instrument cluster and fuel gauge sender unit

DIAGNOSTIC PROCEDURE

DIAGNOSTIC PROCEDURE

Table incomplete in source. The printed source cuts this table off at the right page edge, so some text in the last column is missing.

STEPINSPECTIONACTION
1• Turn the ignition switch to the ON position.
• Verify that the fuel gauge needle does not move after ignition switch is turned off, or the display does not indicate F even though fuel tank is full.
• Is the fuel gauge normal?
Yes Troubleshooting completed.
NoGo to the next step.
2• Start the instrument cluster input/output check mode.
• Select the check code 22.
• Display value is 7-206 ?
Yes Go to the next step.
NoGo to Step 4.
3• Perform the check code 23 inspection.
• Is there any malfunction?
Yes Replace the instrument cluster.
NoGo to the next step.
4• Perform the check code 22 inspection.
• Is there any malfunction?
Yes Go to the next step.
NoGo to Step 6.
5• Turn the ignition switch off.
• Inspect the instrument cluster connector terminals for poor connection (such as damaged/pulled-out pins, and corrosion).
• Are the terminals normal?
Yes Replace the instrument cluster.
NoRepair or replace the terminal.
ACCESSORIES & BODY, CAB – Symptom Troubleshooting (Instrument Cluster) – figure
  • Turn the ignition switch to LOCK position. Repair or replace the wiring harness
  • Remove the instrument cluster. Yes between the instrument cluster and

6

  • Disconnect the instrument cluster connector. GND.
  • Inspect for continuity between the following wiring harnesses.

Parts & tools for this job For 2006 Mazda MX-5

As an Amazon Associate we earn from qualifying purchases.