Workshop Manuals Factory service & repair Mazda
01 General information02 Engine03 Engine performance04 Transmission05 Driveline and axles06 Suspension07 Brakes08 Steering09 Restraints10 Heating and air conditioning11 Electrical12 Accessories and equipment13 Body and cab accessories
Mazda MX-5 (NC) Factory Workshop Manual (2006-2008)05 · Driveline and axles
05 · Transmission

Dust cover removal note

Make
Mazda
Model
MX-5 (NC) Factory Workshop Manual
Year
2006–2008
Section
Rear Axle › Dust cover removal note
Driveline and axlesDust cover removal note · page 1 of 2

See also: live page (the same text is also in the 2008 2.0L manual)

DRIVELINE/AXLES – Rear Axle – figure
Fig. 10: Removing Wheel Bearing From Rear Knuckle Using SST's
Courtesy of MAZDA MOTORS CORP.

DUST COVER REMOVAL NOTE

NOTE: Remove the dust cover only if there is an abnormality.

  1. Place an alignment mark on the dust cover and rear knuckle for proper installation.

Parts & tools for this job For 2006 Mazda MX-5

As an Amazon Associate we earn from qualifying purchases.